Table of Contents
Advertisement
Your washer dryer operates on 110 volts and has a 1,300
watt dryer. It will take a longer time to dry clothes than a
traditional dryer (which operates on 220 volts, 5,000 watts).
However, with the following tips, you can increase the
efficiency of the dryer.
1. DOOR REMAINS LOCKED DURING DRYING: The door
is electronically kept locked drying cycle, with the
Mode+Door Lock light on. This prevents any starting and
shutting the heater, which in turn conserves energy by
trapping the heat.
2. FABRIC SOFTENER: When the Wash and Dry cycles are
set to run consecutively, the preheat function comes on
automatically. In this, the heater is turned on during the last
spin cycle of the wash program. In the Regular Wash
program, the clothes will be getting spun at 1,200 rpm, while
hot air from the dryer will be entering the drum at the same
time. While centrifugal force causes clothes to stick to the
sides of the drum, the hot air will "bake" them to the sides. It
may take 30 minutes or more for the clothes to unstick and
fall into the drum. USING LIQUID FABRIC SOFTENER WILL
CAUSE THE CLOTHES TO UNSTICK IMMEDIATELY. THIS
HELPS DRY CLOTHES FASTER AND CAUSES LESS
WRINKLES.
Your new appliance is carefully engineered product. Many times
what appears to be a reason to call for service, requires nothing
more than a simple adjustment you can easily make in your
own home.
You will be charged for a service call while the appliance
is in warranty if the problem is not caused by defective
product workmanship or materials covered by this
warranty.
To avoid a charge for an unnecessary service call, and before
calling a serviceman, please refer to the troubleshooting section
for situations that you can remedy. This section is included on
pages 16-17 of this Use and Care Book.
1. The washer must be installed on a strong level floor, and in
protected, dry, and well-ventilated area close to a power and
water supply of sufficient capacity.
2. Installation on Carpet or Wood increases vibrations.
• Carpets - place on light carpet only.
• Wood - brace floor with screws and place additional sheets
of plywood before installation.
www.aristonappliances.us
Dryer Efficiency
This appliance is an automatic washer with a capacity of up to:
PRE-INSTALLATION
3.OVERLOADING: The drum has a capacity of
12 lbs. While this is the largest drum available on any
combination washer-dryer, it is smaller than a standard U.S.
washer. The drum should not be overloaded. With too many
clothes, airflow is reduced, increasing drying time. A
maximum of 2/3 of the drum full of clothes is recommeded
for ideal drying.
4. OVER DRYING: This machine uses a condensing dryer.
In this cold water is used to condense the moisture from the
hot air. Since there is no external exhaust system, the
moisture remains in the machine. Frequently, when it seems
the clothes are damp, it is actually the remaining moisture
(like dew). Take clothes out and within a few minutes they
will be dry. Do not overdry the clothes.
5. USE LOW SUDSING DETERGENT: By using low sudsing
detergent, you are preventing suds from entering the
condensing chamber. When suds enter the condensing
chamber, lint particles can clog up the chamber and the fan
blower. Over time, this reduces drying efficiency and may
require the fan blower (impeller) to be cleaned.
Your Washer-Dryer is front loading, with an extra large door
opening for easier access. It has 9 wash cycles in addition
to extra rinse and pre wash cycles.
You will obviously want to obtain the best possible wash. By
reading and following the instructions in this booklet you will
achieve excellent results.
Please, ensure that the instructions are followed. If you should
need any further advice or assistance, please, contact the
dealer where your machine was purchased.
12 lbs.
3. Dryer installation and grounding should be done in
accordance with local codes by a qualified installer.
"Installation Instructions" are included in your Use and Care
manual for the Installer' s reference.
4. The washer should be plugged into a properly grounded
three (3) prong electrical outlet of 120 Volt, 1300 W, 13 A,
60 Hz. It should not be controlled by a wall switch or pull
cord which might be turned off accidentally.
Instructions for installation and use
5
Hide quick links:
Advertisement
Table of Contents
