Using Usals - Tiviar Alpha Plus User Manual

It may be useful to set limits to the movement scope of the dish for easier
manipulation. Repeat these steps two times to set a limit position for the
east and the west.
1. Choose Go to Reference
turn to the reference point.
2. Place the focus on
drive the dish.
3. Choose Set East (soft) Limit
Command to save the dish's current position to use it as a limit position.
Choosing Disable (soft) Limits
positions.

Using USALS

Open the Settings
and then set Positioner
• Dish Longitude: Enter the longitude where the dish is located.
• Dish Latitude: Enter the latitude where the dish is located.
Give the dish a test run to see if it works properly. Repeat these steps for
every desired satellite.
1. Choose Go to Reference
turn to the reference point.
2. Choose Satellite
3. Choose Tuner
option is not available when
under Settings
4. Choose Frequency
5. Choose Go to
S C
from
Move and press the left or right navigation button to
or
from
> Installation > Dish Setting
to USALS. Specify these items correctly:
from
and choose a target satellite.
and determine which of the dish connectors to use. This
Tuner Connection
> Installation >
and select any available transponder.
to rotate the dish so that it faces the target satellite.
Positioner Command
Set West (soft) Limit
Positioner Command
> Positioner Setting
Positioner Command
Dish Setting.
for the dish to re-
from Positioner
clears these limit
for the dish to re-
is set to Loop-Through
menu,
19