Using Diseqc 1.2 - Tiviar Alpha Plus User Manual

Using DiSEqC 1.2

Open the Settings
and then set Positioner
Repeat these steps for every desired satellite.
1. Choose Go to Reference
turn to the reference point at the highest point in its arc. The dish's
movement accuracy may decrease over long-time use. To correct move-
ment errors, choose
2. Choose Satellite
3. Choose Tuner
option is not available when
under Settings
4. Choose Frequency
5. Choose Go to Stored Position
dish, so that it faces the target satellite.
6. Place the focus on
to finely drive the dish east or west for the best signal. The dish rotates
continuously as long as either of these buttons is held down.
7. Choose Store Satellite Position
dish's current position for the target satellite.
18
> Installation > Dish Setting
to DiSEqC 1.2.
from Positioner Command
(Re-) Calculate
and choose a target satellite.
and determine which of the dish connectors to use. This
Tuner Connection
> Installation >
and select any available transponder.
from
Move and press the left or right navigation button
> Positioner Setting
from Positioner
is set to
Dish Setting.
Positioner Command
from Positioner Command
3.3 U  M D
menu,
for the dish to re-
Command.
Loop-Through
to rotate the
to save the