Installing Or Replacing The Optical Drive - Lenovo ThinkServer TS200v Hardware Maintenance Manual

7. Position the new memory module over the memory slot. Make sure that the
notch 1 on the memory module aligns correctly with the key 2 in the
memory slot. Press the memory module straight down into the memory slot
until the retaining clips close.
Figure 14. Installing a memory module
8. Reinstall all parts that have been removed.
9. Go to "Completing the parts replacement" on page 61.

Installing or replacing the optical drive

Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, "About this manual," on page 1 and the Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 33.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on
page 34.
4. Depending on whether you are installing or replacing an optical drive, do one
of the following:
v If you are installing a secondary optical drive, remove the plastic panel in the
front bezel for the drive bay you want to use. If there is a metal static shield
installed in the drive bay, remove the metal static shield.
v If you are replacing an optical drive, disconnect the signal cable and the
power cable from the rear of the optical drive, press the blue release button
1 , and then slide the optical drive out of the optical drive bay.
Chapter 6. Replacing FRUs
41