Removing The Server Cover - Lenovo ThinkServer TS200v Hardware Maintenance Manual

Removing the server cover

Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, "About this manual," on page 1 and the Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the server cover.
CAUTION:
Turn off the server and wait three to five minutes to let the server cool before
removing the server cover.
To remove the server cover, do the following:
1. Remove any media from the drives and turn off all attached devices and the
server.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output (I/O) cables, and any other cables
that are connected to the server. See "Front view" on page 23 and "Rear view"
on page 23.
4. Remove any locking device that secures the server cover, such as a padlock or
an integrated cable lock.
5. Remove any thumbscrews that secure the server cover.
Chapter 6. Replacing FRUs
33