Test Tone
For proper Dolby Pro Logic
operation, a test tone is used
to calibrate the volume set-
tings of the speakers. A noise
will be heard cycling, in order,
from the front left, center,
right, and both surround
Tone
speakers.
Balance
Surround
–
+
Calibrate
Calibrate
Push "+" on the remote
Push "Calibrate" on the
remote control until "Balance"
control to adjust the balance
appears in the display.
toward the right speaker.
Center Channel Volume
Surround
–
+
Calibrate
Calibrate
Push "Calibrate" on the
Push "+" on the remote
remote control until "Center"
control to increase the volume
appears in the display and the
of the center channel.
corresponding LED on top of
the display is lit.
Using the remote control, push
"Tone." Then adjust the Center
Aux
and Surround levels until the
volume of all the speakers is
Surround
the same during the test.
–
+
Note: The test tone is used to
calibrate the performance of
Calibrate
the system. When listening
to an actual recording, the
Surround
Surround
–
+
–
Calibrate
Push "–" on the remote
control to adjust the balance
toward the left speaker.
Surround
Surround
–
–
+
Calibrate
Push "–" on the remote
control to decrease the
volume of the center channel.
volume level of the surround
channels is generally much
lower than that of the front
channels. In fact, when
listening to a movie, virtually
all of the dialogue and a sub-
stantial number of the effects
are reproduced through the
center channel.
+
+
– 18 –