Auto On/ Manual On Switch; In/Out Din Jacks; Ac Inlet - JBL Synthesis S800 User Manual

3.0
OPERATION AND
CONTROLS

8. Auto On/ Manual On Switch

Put this switch in the Auto On position if the amplifier
is being used as part of a JBL Synthesis System. When
used in this way, the S800 will automatically turn on
when the power switch is depressed and the surround
processor is activated. For other installations, or
should individual control of each component be
desired, put this switch in the Manual On position.
The amplifier will then be controlled solely by the front
panel switch.

9. IN/OUT Din Jacks

If you are using the amplifier as part of a JBL Synthesis
System, it is necessary to use these jacks to interconnect
to other system components, so that control signals
(power on/off and music/cinema mode switching) can
be transmitted from one unit to the next, starting at the
surround processor, through the equalizer and amplifiers,
and ending at the speakers. Follow the connection
diagrams on the following pages corresponding to the
appropriate Synthesis system for detailed information
12
regarding these connections. Make connections to
these jacks only as shown in the diagrams. If these
jacks are used in any other manner, e.g., to control
electric screens, the unit can be damaged and the
warranty will be void. For specific electrical information
on these jacks, contact JBL Synthesis Customer
Service at (800) 336-4JBL.
Do not plug anything into these jacks if you are
not using the S800 with a JBL Synthesis System.

10. AC Inlet

Your S800 is shipped with an IEC-type removable
power cord that mates with the AC inlet on the rear
panel. To ensure proper operation, use the supplied
power cord. This amplifier is NOT a multi-voltage
unit; using a power cord with a different connection to
the AC wall receptacle will void the warranty.
3.0
OPERATION AND
CONTROLS