Fuse Replacement; General Operation - GME G-Deck Instruction Manual

Fuse rePlaCement

if any of the fuses blow, replace them with a standard 30 mm
3 aG type of the same rating, if the fuse blows a second time
contact your GmE dealer for advice.
the following fuse ratings are used:
Yellow 'memory B+' lead: 15 amp.
red 'ignition switch' lead: 0.5 amp.

GENERAL OPERATION

general FunCtions
Power on/oFF
to turn the G-DEK on, press the button. the unit will
display 'WElcomE' then resume the mode and settings that
were selected when last turned off.
to turn the G-DEK off, press and hold the
will display 'GooDBYE' and will switch off. While the G-DEK is
switched off it will display the clock.
G - D E K i n s t r u c t i o n m a n u a l
Back lighting
While the G-DEK is switched on, briefly press the
to change the brightness of the back lighting. there are three
levels of back lighting available - off, dim and bright.
audio Controls
the VolumE, Bass, trEBlE, miD ranGE, BalancE, FaDEr
and suB WooFEr settings are adjusted using the large
selector knob. the default control setting is the Volume.
to adjust the Volume, rotate the knob.
to select an alternative audio control, press the
repeatedly until the desired function is displayed on the
lcD ('Bas', 'trE', 'miD', 'Bal', 'FaD' or 'suBW'). adjust the
selected control using the knob.
if no adjustment is made for five seconds the control returns to
the Volume setting.
button. the unit
note: the Bass, miD and trEBlE settings on the
button are only available when the Equaliser is set to manual
(the icon is displayed). see instructions below to adjust
the equaliser settings.
equaliser
the G-DEK has four preset Graphic Equaliser settings to
button
enhance your audio listening pleasure. these are 'classic',
'Pop', 'rock' and 'Jazz'. Each setting provides a preset
adjustment of Bass, midrange and treble settings to suit the
selected music style.
to cycle through the preset Equaliser settings, press the
button repeatedly. icons for classic
rock or Jazz
if you prefer to manually adjust the Bass, midrange and treble
controls set the Equaliser to off
button
treble settings can now be selected and adjusted manually
using the button.
loudness
the loudness function provides a low frequency Bass boost
to the audio output at lower volume settings. there are three
loudness settings – loud 01, loud 02 and off. loud 01
provides a small increase in bass while loud 02 results in a
greater boost.
to cycle through the loudness settings press the
repeatedly. the selected loudness setting is displayed
momentarily along the bottom edge of the lcD. Whenever
the loudness function is active the 'louD' icon is displayed.
, Pop
will be displayed on the lcD.
. the Bass, midrange and
button
Pa G E 1 6