Radio Operation; Am/Fm Tuner - GME G-Deck Instruction Manual

mute
Press the button to temporarily silence the audio
output. 'mutE' will flash on the display to confirm the
G-DEK has been muted and the speakers will remain quiet.
Press the button again to restore the previously
selected audio level.
Clock
the clock will normally be displayed whenever the G-DEK is
switched off. to manually display the clock at any time, briefly
press the (display) button. after five seconds the display
will automatically return to its original status.
to adjust the time:
1. Press and hold the button. the time will flash.
2. turn the selector knob clockwise to adjust the minutes or
counter clockwise to adjust the hours.
3. When the correct time is displayed, briefly press the selector
knob to store the time and return to the normal display.
the time can be displayed in either 12 hour or 24 hour mode.
refer to the menu settings for details.
G - D E K i n s t r u c t i o n m a n u a l
input source selection
Press the srC button repeatedly to cycle through the G-DEK's
available input sources. the icon for the selected input source
will be displayed. inputs include am/Fm tuner, sD card, usB
memory stick, auxiliary inputs 1 & 2, iPod and DaB tuner
(Gm550).
note: only input sources that are connected can be selected.
the G-DEK will automatically skip over input sources that are
not available (connected) e.g. if an sD card is not inserted the
sD card source cannot be selected.
Whenever the G-DEK is switched on it will automatically
attempt to return to the input source that was last selected.

RADIO OPERATION

am/Fm tuner

to select the am/Fm tuner press the srC button repeatedly
until the icon is displayed.
Country selection
the G-DEK supports both European and usa band settings.
the settings control the different band edges and frequency
tuning steps used by these countries (for details on frequencies
and tuning steps see 'specifications' at the end of this
manual).
When first connected, the G-DEK will default to the European
setting which is compatible with most countries (including
australia). For operation in the usa, select the usa country
setting.
to switch between European and usa band sets:
1. While the radio is on, hold the memory button while
pressing the button. the radio will display 'Goodbye'
and switch off.
2. Press the button to switch the radio on again. 'usa' or
'Europe' will be displayed to confirm the selected band.
note:
if all power is disconnected from the G-DEK, the unit
will automatically return to the default European frequency
bands.
Band selector
there are three Fm bands labelled Fm1, Fm2 and Fm3 and
two am bands labelled am1 and am2. Each band has six
station memories allowing you to store up to 18 Fm and
Pa G E 1 7