Table of Contents
Advertisement
T e s t i n g T h e W A - 9 0 0
Test your system before an emergency occurs.
Do not forget to review programmed information and verify all parts of your system thoroughly before relying
on the dialer to notify you about a wandering patient.
The test mode tests the stored information, not the full functionality of the dialer. To test the full functionality of
the dialer, the unit must be tested in the operate mode. In the test mode, the dialer will not make more than one
attempt per number dialed or play the OGM more than once.
STEP 1: Press the "M" Mode key until the screen reads:
STEP 2: Press "1" to display the T-Line configuration. The data will scroll through all selections.
Press "2" to scroll to the next section.
Note: To fully test the input, the dialer must be connected to a telephone line. If the dialer
does not detect a dial tone, it will not continue testing the programmed numbers and will
display:
NO DIAL TONE!
If you have gotten the NO DIAL TONE! screen, connect the dialer to a telephone line and
press the "M" key until the TEST: T-LINE prompt appears. Continue testing the input by
selecting "2" in Step 1 and skip to Step 3.
STEP 3: The screen will read:
STEP 4: Press "1" to test input. Verify the settings as the screen scrolls through by comparing the information
displayed with that specified on your Program Planner. Listen to your recorded message to ensure that the
correct OGM (if programmed) is delivered.
Press "2" to scroll to the next section.
STEP 5: To test the operation of your entire system, set Mode to OPERATE and proceed as explained in the
next section: Operating Your System.
NOTE: IN ORDER TO TEST IN THE OPERATE MODE, AT LEAST, 1 PHONE NUMBER AND OGM OR
1 PAGER NUMBER MUST BE PROGRAMMED. IF PROGRAMMING IS NOT COMPLETE, THE
DIALER WILL DISPLAY: PROGRAMMING IS
This message will be displayed for 2 seconds then the dialer will switch to the Program mode.
Make sure you notify the receiving party of your intent to call them, and tell them it is just a
test.
Test your system on a regular basis, at least once a week.
In the TEST mode, a beep will be heard every 30 seconds. This is to indicate that the dialer is
not in the OFF or OPERATE mode.
TEST: INPUT
1(YES) 2(NO)
NOT COMPLETE!
TEST: T-LINE
1(YES) 2(NO)
16
Advertisement
Table of Contents
