Table of Contents
Advertisement
RS‐232/485 RF Modem Product Manual – MAN0782‐02
WR (Write) Command
WS (Sticky Warning Numbers) Command
<(Special)> WR Command writes configurable
parameters to the modem's non-volatile memory
(Parameter values remain in the modem's
memory until overwritten by future use of WR Command).
If changes are made without writing them to non-volatile memory, the modem reverts back to
previously saved parameters the next time the modem is powered-on.
<Diagnostics> WS Command reports the warning
numbers of all warnings which have been active
since the last use of WS or WN command,
including any warnings which are currently active.
No further information is shown.
This command also resets all non-zero warning counts, except for warnings that are presently
active, which are set to 1.
AT Command: ATWR
Binary Command: 0x08
AT Command: ATWS
Parameter Range (read-only): 1 – 8
Number of bytes returned: 1
Page 49
Advertisement
Table of Contents
