Table of Contents
Advertisement
Available languages
Available languages
INDOOR UNIT INDICATORS
TEMPORARY
SWITCH
OPERATION INDICATOR
TEMPORARY SWITCH
Use this switch to start and stop when the remote controller does not work. [Use non-conductor stick
(example: toothpick)]
By pressing the temporary switch, the operation is done in previously set operation mode.
●
When the operation is done using the temporary switch after the power source is turned off and turn
●
on again, the operation is done in automatic mode.
FILTER LAMP
When the device is operated for a total of about 200 hours,
the FILTER lamp lights to indicate that it is time to clean
the fi lter. The lamp goes out when the "
SWING)" button is pressed while the
"STANDBY MODE".
OPERATION LAMP
This lamp lights during operation.
The OPERATION LAMP fl ashes in the following cases
during heating.
(1) During preheating
(2) During defrosting
TIMER LAMP
This lamp lights when the timer is working.
Temporary Switch
Temporary Switch
Press
Press
Non-conductor Stick
Non-conductor Stick
– 5 –
For about 2–3 minutes after starting up.
Defrosting will be performed about once every one
hour when frost forms on the heat exchanger of the
outdoor unit, for 5–10 minutes each time.
(AUTO
device is on
TEMPORARY
SWITCH
Advertisement
Table of Contents
