Trouble Shooting - Health Stream Treadmill Owner's Manual

TROUBLE SHOOTING

TROUBLE SHOOTING GUIDE
SYMPTOM
Console display LCD's
do not illuminate
Scrambled digitalis on
console LCD
Show E1
The most happened symptom is current overload protection. And show E1(error 1)
on monitor. E1 is to inform the runner to examine your treadmill by yourself to avoid
the damage happened on treadmill. The runner can follow the below steps to do the
examination.
1). E1 would be happened by electricity system at your home. Sudden big current
would cause E1. Please turn off the on-off switch, then turn on the switch to
resume the using.
If it still happened, the most reason is too much friction between the running belt
and the running deck.
2). Please do lubrication according to LUBRICATION MAINTENANCE instructions.
Enough lubrication will improve the performance and maximum the treadmill life.
3). Keep clean under running belt.
4). Check the tension between roller and running belt. (please see BELT
ADJUSTMENT)
5). The damaged running belt will increase the current and be easy to cause E1. Wear
proper footwear while using. It can avoid to damage the running belt.
If still can not solve it, please call your dealer for helps.
CAUSE
a. No power to treadmill
b. Console wire connector not
connected or incompletely
connected
c. Overload protection is activated
Damaged console
a. RPM sensor problem
b. Senor wire not connect to
controller or improper connection
c. Motor wire not connected
d. Console wires not connect properly
e. Controller damaged
f. Overload protection is activated
Check the on-off switch
Turn off, then turn on power.
Push START,
Check all of connected wires,
if still not illuminated, a service
is required
10
SOLUTION
Service required
Service required
Check the lubrication, running
belt tension, turn off, then
turn on power