Care 7 Maintenance; Care And Maintenance - Health Stream Treadmill Owner's Manual

CARE & MAINTENANCE
WARNING!:To prevent electrical shock, be certain the treadmill is turned off and unplugged before
cleaning or routine maintenance.
RUNNING BELT AND RUNNING DECK LUBRICATION
For maximum treadmill life, this treadmill needs a routine lubrication as part of a general maintenance
for the machine. The routine maintenance procedure will prevent premature wear of the running belt,
running deck and drive motor system. The recommended lubrication schedule as:
This schedule is the recommended application for a single user, up to 20~30 minutes per time. 3~4
times per week. For lubrication, you can contact your dealer.
CLEANING
Perspiration should be wiped from the console and treadmill surface after your workout.
You should wipe down your treadmill once a week with a water dampened, soft cloth. Be careful not get
excessive moisture on the display panel as this might cause an electrical hazard or electronics to fail.
STORAGE
Store your treadmill in a clean and dry environment. Ensure the master power switch is off and is un-un-
plugged from the electrical wall outlet.
MOVING
This treadmill has been designed and equipped with wheels for easy mobility. Before moving, ensure
the master power switch is in the off position and the power cord is unplugged from the electrical outlet.
FOR CONSUMER/HOME USE ONLY!!
This treadmill is designed for home use only. Do not use for light institutional or commercial.
LUBRICATION
It is important to take good care of your treadmill deck (the walking surface underneath the belt). A good
silicone lubrication will also improve the performance of your treadmill.
NOTE: Use the silicone that is supplied with the treadmill. Additional silicone lubricant can be
purchased from your retail store.
WARNING: STOP the treadmill and remove the safety key before lubricating the running deck.
A). Find the silicone bottle. It is located in the hardware kit package included with this treadmill..
B). Find a straw and put it onto the silicone bottle as the drawing shows.
C). Spray silicone evenly on treadmill deck as the drawing shows. (ATTENTION : The treadmill
MUST BE STOPPED before applying the silicone lubricant. This is to prevent injury, otherwise
the edge of the running belt may cut you or your fingers could be crushed by the rollers. )
Do not put too much silicone on the deck. Excessive lubricant may cause slippage of the belt on the
rollers.
HOW TO SPRAY SILICONE ON DECK?
A
Silicone bottle
USAGE LUBRICATION
1~6kph Every 3 months
6~12kph Every 2 months
12~16kph Every 1 months
B
Straw
Put on straw
Lubricant for
running deck
C
9