Pioneer DV-360-S Service Manual page 64

1
ID DATA Input Mode
To enter ID DATA Input Mode, with the ID number set, press the
1
ESC key then the STEREO key.
A
When the STEREO key is pressed, the unit enters ID DATA
2
Input Mode.
[Player's ID Number Setting]
ID Number ?
[ 0 0 0 0 0 0 0 0 1 ]
Compare
> ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
B
<CLEAR> Exit
<STEREO> ID Data Setting Mode
2
Input ID Number !
If the ID DISC (GGV1085) is loaded in this mode, the unit
3
automatically starts reading the data.
(If the ID DISC has already been loaded, the unit does not start
reading the data. In this case, open then close the tray.)
C
To exit this mode, press the CLEAR key. While data are being
4
read from the ID DISC (GGV1085), you cannot exit this mode.
[Player's Data Input Mode]
<CLEAR> Exit
4
D
Insert The ID Data Disc !
E
F
64
1
2
When writing of the data read from the disc to flash ROM is
5
completed, "Rom Write OK!" is displayed. After seeing this
message, you can exit this mode by pressing the CLEAR key.
Note: Whether or not the data have been written to flash ROM can
be confirmed by watching for the message "Rom Write OK!"
being displayed after the disc is read.
If the data cannot be read from the disc, "Disc Error!" is
6
displayed on the screen, and the disc is ejected.
• Indication when the data have not been set
If no ID data are set after the ID number is changed, the message
"NO ID DATA" flashes on the screen and FL display for a few
seconds after the power is turned on or during Stop mode.
DV-360-S
2
3
[Player's Data Input Mode]
Rom Write OK!
5
<CLEAR> Exit
[Player's Data Input Mode]
Disc Error!
6
<CLEAR> Exit
3
4
4