Pioneer DV-360-S Service Manual page 61

5
Error Name
SPINDLE ERROR (0 x 6∗)
Spindle on error 0 x 61 Spindle on could not be completed
Spindle off error 0 x 62 Spindle off could not be completed
Spindle lost error 0 x 63 Spindle lost control
Spindle CAV error 0 x 64 CAV on could not be completed
Spindle CLV error 0 x 65 CLV on could not be completed
SPINDLE TIMEOUT (0 x 7∗)
Spindle on timeout 0 x 71 Did timeout at spindle on
Spindle off timeout 0 x 72 Did timeout at spindle stop
Spindle lost timeout 0 x 73 Did timeout at spindle backup
Spindle CAV timeout 0 x 74 Did timeout at CAV on
Spindle CLV timeout 0 x 75 Did timeout at CLV on
ACQUISITION ERROR (0 x 8∗)
PLL lost error 0 x 83 PLL is lost
ACQUISITION TIMEOUT (0 x 9∗)
PLL lost timeout 0 x 93 Did timeout at PLL backup
DECODER ERROR (0 x a∗)
ID lost error 0 x a3 ID is not readable
DECODER TIMEOUT (0 x b∗)
ID lost timeout 0xb3
DEVICE ERROR (0 x d∗)
SRAM error 0 x d1 Cannot access SRAM
FAILSAFE (0 x e∗)
Unexpected error 0 x e1
5
6
No. Causes
Did timeout at ID backup
Unexpected error
6
7
Check Item
Are not there a dirt or a scratch in
the Disc?
Is FG output from the driver?
Is spindle rotating?
Is FG output from the driver?
Is the PDM output from Front End?
Are not there a dirt or a scratch in
the Disc?
Are not there a dirt or a scratch in
the Disc?
Are not there a dirt or a scratch in
the Disc?
Are not there a dirt or a scratch in
the Disc?
Power supply of SRAM
Is not bus line short-circuiting?
DV-360-S
7
8
Possibility of Trouble Remarks
1. Spindle motor
2. Spindle driver
1. Spindle motor
2. Spindle driver
3. Front End IC
1. Pickup
2. Front End IC
1. Pickup
2. Front End IC
1. Pickup
2. Front End IC
1. Pickup
2. Front End IC
1. SRAM
2. Front End IC
3. Front End-SRAM bus line
1. software runaway
3. Software bug
61
8
A
B
C
D
E
F