Makita HM1202C Instruction Manual page 7

Center for this lubrication service.
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle.
002967
Remove the crank cap using a socket wrench. Rest the
tool on the table with the bit end pointing upwards. This
will allow the old grease to collect inside the crank
housing.
1
002968
Wipe out the old grease inside and replace with a fresh
grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 30 g; 1 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
1
002969
Reinstall the crank cap and tighten with the socket
wrench.
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the terminals or lead
•
wires especially when wiping out the old grease or
installing the handle.
1. Screws
1
1. Socket wrench
2. Crank cap
2
1. Hammer grease
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point (SDS-max)
•
Cold chisel (SDS-max)
•
Scaling chisel (SDS-max)
•
Clay spade (SDS-max)
•
Bit grease
•
Hammer grease
•
Safety goggles
•
Plastic carrying case
•
7
or attachments
Only use accessory or
are