Pioneer DVR-210-S Manual page 53

6 When the ID data has been read, the data is written to the
FLASH-ROM.
(The FL display indicates "WRITE ID.")
[Recorder's ID Data Setting]
Wait Rom Writing !
6
How to Confirm the ID Number
1 Press ESC + STEREO sequentially with an ID number already
set, and the unit enters the ID number confirmation mode.
2 The set ID number is displayed on the screen (and on the FL
display), permitting you to confirm it.
To exit this mode, press CLEAR .
3
[Recorder's ID Number Setting]
ID Number ?
[ 0 0 0 0 0 0 0 0 1]
2
Compare
> * * * * * * * * *
<CLEAR> Exit
3
Input ID Number !
How to Clear the ID Number
1 Press ESC + STEREO sequentially with an ID number already
set, and the unit enters the ID number confirmation mode.
2
Input the same number as the ID number you have set.
[Recorder's ID Number Setting]
ID Number ?
[ 0 0 0 0 0 0 0 0 1]
Compare
> * * * * * * * * *
2
<CLEAR> Exit
<STEREO> ID Data Setting Mode
Input ID Number !
7 When the ID data has been written to the FLASH-ROM, the
message "Rom Write OK" is displayed on the screen.
(The FL display indicates "ID DATA OK.")
8 After confirming this message, press CLEAR to exit the input
mode.
[Recorder's ID Data Setting]
Rom Write OK !
7
<CLEAR> Exit
8
3 After inputting the number, press STOP .
Only when the entered number matches the set ID number, the
ID number is cleared and the unit exits this mode.
If the numbers do not match, you must return to step 2.
( STOP is not accepted until 9 digits are entered.)
[Recorder's ID Number Setting]
ID Number ?
[ 0 0 0 0 0 0 0 0 1]
Compare
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY> Enter
3 <STOP> Memory Clear
<STEREO> ID Data Setting Mode
Input ID Number !
52.