DeWalt DCR016-XE Instruction Manual page 9

NOTE: The fuel gauge is only an indication of the charge left on the battery pack.
It does not indicate radio functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please contact Stanley Black
& Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call 1800 338 002 or (NZ)
0800 339 258.
AC OPERATION
Unwrap power cord and plug into 230 V AC wall outlet.
OPERATING THE RADIO (FIG. 2)
POWER/VOLUME ADJUSTMENT
1. To turn the radio on, press the power button (a).
2. Turn the dial (b) clockwise to increase the volume. To decrease the volume, turn
anticlockwise.
MODE FUNCTION
To choose one of the mode functions (FM, AM, or AUX), push the mode button (d)
until the desired function is found. For example, if the radio is on FM, seen in upper
left portion of LCD display (h), push the mode button twice to change to AUX.
TUNE OR SEEK FUNCTION
There are two methods for finding the desired frequency.
To Tune: Push the right arrow to move the tuner up the frequency band. Push the left
arrow to move the tuner down the frequency band.
To Seek: Press the right arrow button (c) once and release. The tuner frequency will
increase to seek the first radio station with acceptable clarity and stop at that station.
The right arrow button may be pressed again to continue seeking a radio station at
higher frequencies. The left arrow button may be pressed to seek radio stations at
lower frequencies. The seek function is available in AM and FM modes.
TO PROGRAM THE MEMORY BUTTONS
Ten FM and five AM radio stations may be independently set. After programming the
buttons, pressing 1, 2, 3, 4 or 5 will instantly change the frequency to the preset sta-
tion.
1. Turn power on.
2. Set the radio to desired station (see Tune or Seek Function).
3. Press and hold one of the desired memory buttons (f). The station setting
begins flashing in the LCD display (h). Continue to hold the button down until the
flashing stops. The memory button is now set.
4. Repeat steps 2 and 3 to set the other memory buttons.
TO PROGRAM THE CLOCK
1. Turn power on (see Power/Volume Adjustment).
2. Push and hold clock button (e) until the LCD display (h) begins flashing.
3. Press the left arrow button repeatedly to increment the hour of the displayed
time or press and hold the button to increment continuously. Use the right arrow
button to adjust the minute in the same manner.
Note: If you do not press a button within
5 seconds, the clock programming feature will automatically return to the
previous setting.
4. Once the time is set, push and hold the clock button until the time on the LCD
display stops flashing.
TO ADJUST THE EQ
Sound quality can be adjusted by changing the equalization of the bass or treble of
the radio.
1. Press the EQ button (g) to select bass or treble.
2. Press the right arrow button to increase the selected setting or the left arrow
button to decrease it.
3. Once desired adjustment is achieved, leave all buttons released for more than
3 seconds. The procedure will exit and the equalization adjustment will remain
activated.
7