DeWalt DCR017-XE Instruction Manual

DeWalt DCR017-XE Instruction Manual

Charger/radio

Advertisement

INSTRUCTION MANUAL
DCR017-XE
CHARGER/RADIO

Advertisement

Table of Contents
loading

Summary of Contents for DeWalt DCR017-XE

  • Page 1 INSTRUCTION MANUAL DCR017-XE CHARGER/RADIO...
  • Page 3: Definitions: Safety Guidelines

    • Remove the battery pack. Switch off before leaving it unattended. Remove the Definitions: Safety Guidelines battery pack when not in use, before changing accessories or attachments and before servicing. The definitions below describe the level of severity for each signal •...
  • Page 4: Grounding Instructions

    • Do not operate charger/radio if it has received a sharp blow, been dropped, or WARNING: Shock hazard. Do not allow any liquid to get inside charger/radio. otherwise damaged in any way. Take it to an authorised service center. Electric shock may result. •...
  • Page 5: Extension Cords

    READ ALL INSTRUCTIONS FIG. 1 DCR017 • Do not charge or use the battery pack in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery pack from the charger may ignite the dust or fumes. •...
  • Page 6: Charge Indicators

    Indicator Light Operation • If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, PACK CHARGING the battery electrolyte is composed of a mixture of liquid organic carbonates and lithium salts.
  • Page 7: Important Charging Notes

    NOTE: This could also mean a problem with a charger. power supply when there is no battery pack in the cavity. Unplug the charger/ radio before attempting to clean. PROBLEM POWERLINE 7. Do not freeze or immerse the charger in water or any other liquid. Some chargers have a problem powerline indicator.
  • Page 8 FIG. 3 3. Unscrew the screw (K) on the battery door (L). 4. Press down on the battery door latch and pull to open. 5. Install the coin cell battery (M) according to the diagram inside the coin cell battery area. 6.
  • Page 9 To perform an Auto Scan: the level of charge in the battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged. 1. Press the menu button (E), scroll through the options by pressing the right arrow NOTE: The fuel gauge is only an indication of the charge left on the battery pack.
  • Page 10 To Seek: Press and hold the right arrow button (C) once and release. The tuner fre- To adjust the clock manually: (FM and DAB mode) quency will increase to seek the first radio station with acceptable clarity and stop at that station. The right arrow button may be pressed again to continue 1.
  • Page 11 Repairs 4. AM reception will most likely be clearer when powered FIG. 6 by a battery pack. This charger and battery pack are not serviceable. Servicing at an authorized service centre is required to avoid damage to static sensitive internal components. 5.
  • Page 12 Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (APR13) Part No. N294527 DCR017-XE Copyright © 2013 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...

Table of Contents