DeWalt DCR016-XE Instruction Manual

DeWalt DCR016-XE Instruction Manual

Xr li-ion job site radio

Advertisement

INSTRUCTION MANUAL
DCR016-XE
JOB SITE RADIO

Advertisement

Table of Contents
loading

Summary of Contents for DeWalt DCR016-XE

  • Page 1 INSTRUCTION MANUAL DCR016-XE JOB SITE RADIO...
  • Page 3: Definitions: Safety Guidelines

    CAUTION: Burn hazard. To reduce the risk of injury, charge only D WALT Definitions: Safety Guidelines rechargeable batteries. Other types of batteries may burst causing personal injury and damage. The definitions below describe the level of severity for each signal word.
  • Page 4: Extension Cords

    SAVE THESE INSTRUCTIONS • Never force the battery pack into the charger. Do not modify the battery pack in any way to fit into a non-compatible charger as battery pack may rupture Extension Cords causing serious personal injury. Consult the chart at the end of this manual for compatibility of batteries and chargers.
  • Page 5: Important Safety Instructions For All Battery Chargers

    • When operating a charger outdoors, always provide a dry location and use an WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or extension cord suitable for outdoor use. Use of a cord suitable for outdoor use flame.
  • Page 6: Charge Indicators

    3. The completion of charge will be indicated by the red light remaining ON WEAK BATTERY PACKS: Weak batteries will continue to function but should not be continuously. The pack is fully charged and may be used at this time or left in the expected to perform as much work.
  • Page 7: Storage Recommendations

    COMPONENTS (FIG. 2–4) d. If charging problems persist, take the radio, battery pack and charger to your local service center. WARNING: Never modify the radio or any part of it. Damage or personal injury 5. The battery pack should be recharged when it fails to produce sufficient power could result.
  • Page 8: Assembly And Adjustments

    ASSEMBLY AND ADJUSTMENTS Installing and Removing the Battery Pack (Fig. 4) WARNING: To reduce the risk of serious personal injury, turn the radio off and NOTE: To ensure maximum performance and life of Li-Ion batteries, charge the bat- disconnect the battery pack before making any adjustments or removing/installing tery for a minimum of 10 hours before first use.
  • Page 9 1. Turn power on. NOTE: The fuel gauge is only an indication of the charge left on the battery pack. It does not indicate radio functionality and is subject to variation based on product 2. Set the radio to desired station (see Tune or Seek Function). components, temperature and end-user application.
  • Page 10: Maintenance

    IMPORTANT RADIO NOTES (FIG. 6) CHARGER CLEANING INSTRUCTIONS FIG. 6 WARNING: Shock hazard. Disconnect the charger from the AC outlet before 1. The radio will run up to 8 hours on a fully cleaning. Dirt and grease may be removed from the exterior of the charger using a charged 4.0 amp hour battery.
  • Page 12 Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (APR13) Part No. N294539 DCR016-XE Copyright © 2013 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...

Table of Contents