Fujitsu fi-4750C Operator's Manual page 90

No. Item
17 ADF Edge Erasing
18 FB Edge Erasing
19 Select light source
20 Line Enhance mode
21 Ink remain
22 Numbering print
* This offset refers to the difference from the value adjusted by automatic offset adjustment.
** Some restrictions apply to the detection of a double feed.
Description
Adjusts the edge areas to be erased from
the image scanned by the automatic
document feeder(ADF).
Adjusts the edge area to be erased from
the image scanned by the flatbed (FB).
Selects a light source in reading in
unicolor.
Select this mode when blur of color should
be prevented. However, the reading speed
reduces to half.
Resets the ink remain counter.
Enables or disables the numbering
counter when the fi-475 Imprinter is
installed.
(Continued)
Selectable
Default
parameters
Left/Right: Left/Right:
0 to 15mm 0 mm
Top: Top:
0 to 15mm 0 mm
Bottom: Bottom:
-7 to +7mm 0 mm
Left/Right: Left/Right:
0 to 15mm 0 mm
Top: Top:
0 to 15mm 0 mm
Bottom: Bottom:
0 to 15mm 0 mm
R/G/B//W G
On/Off Off
Reset/No No
On/Off Off