Names And Functions Of Each Part - Hitachi CP-X955W Operating Manual

8
Downloaded from www.Manualslib.com

Names and functions of each part

Main unit
Speaker
Handle
Cooling fan Lens Remote control
(exhaust) sensor
Lens cover Lever
•
Use the remote control transmitter within the range
of about 16 feet from the remote control sensor
and within 30° to both the left and right.
VIDEO input terminal
(on video-equipped models only)
S-VIDEO input terminal
Mini DIN 4pin connector (1/2)
VIDEO input terminal
RCA Jack (1/2)
AUDIO L/R input terminal
RCA Jack (1/2)
MAIN POWER switch
Main power ON/OFF switch.
\: OFF
 : ON
manuals search engine
LAMP indicator
This lights when the
lamp does not light.
(See page 29)
Remote control
sensor
Cooling fan
(in take)
INPUT button
To select the input source.
Each time this button is pressed, the input source
is changed in sequence as shown below.
RGB1
S-VIDEO VIDEO L AUDIO R
AUDIO AUDIO
IN OUT
AC SW
AC IN
AUDIO output
AC IN socket
terminal (RGB/VIDEO)
Connect the provided
Stereo mini jack
power cord.
AUDIO input terminal
Stereo mini jack (1/2)
ON indicator
This blinks in the standby mode
and lights in the operation
mode. (See page 29)
STANDBY / ON
button
Power ON/OFF button.
OFF sets the unit in
standby mode.
(See page 12 ~ 13)
TEMP Indicator
This lights when
temperature inside the
projector is too high. (See
page 29)
MUTE button.
(See page 9)
ZOOM button
Adjusts picture size.
(See page 12)
FOCUS button
Adjusts focus. (See page 12)
MENU button
Picture adjustments.
Refer to page 14 ∼ 18 for
details.
RESET button
Resets unit to factory
settings. (See page 14)
RGB2 VIDEO1 VIDEO2
RGB IN
RGB input terminal
RGB input terminal
D-sub 15pin shrink
terminal (1/2)
RGB output terminal
RGB output terminal
D-sub 15pin shrink
RGB OUT
terminal
RGB output can be displayed
even in the standby mode.
CONTROL
CONTROL terminal
D-sub 15pin shrink terminal