Connection To The Control Signal Terminal - Hitachi CP-X955W Operating Manual

Hide thumbs Also See for CP-X955W:
Table of Contents

Advertisement

22
Downloaded from
www.Manualslib.com

Connection to the control signal terminal

1. Control signal terminal
.
Mouse
Pin No
RS232C
PS/2
ADB
1
2
CLK
DATA
3
DATA
4
5
6
SELO
SEL0
7
RTS
RTS
RTS
8
9
+5V
+5V
10
GND
GND
GND
11
12
13
RDP
14
TDP
15
Caution
Turn off the power of both the projector and computer before connecting.
Connect the computer to the control terminal of the projector using an appropriate cable.
Refer to the instruction manual of each device before connecting.
2. Mouse emulation
(1) Connect the projector and the mouse terminal of computer using an appropriate cable, while the projector
and the computer are turn off because mouse emulation don't work.
(2) Turn on the projector (The ON indicator will light up orange.).
(3) Press the INPUT of the projector or RGB 1/2 button of the remote control transmitter and select the input
connection.
(4) Turn on the computer.
(5) Start mouse emulation mode.
If can not start mouse emulation, reset the computer. (With soft reset or reset switch)
(6) See on the page 9 about to operate the remote control transmitter.
(7) Operation speed of the mouse will vary according to the pressing force on the DISK PAD button.
Caution
• In some note computers which have internal pointing device, mouse emulation don't work
without setting the internal pointing device disabled. In this case, set the internal pointing
device disabled in BIOS setting. After setting in BIOS, operate (1) ~ (5) Please check its
hardware manuals to disable internal pointing device in BIOS setting.
• In some computers, mouse emulation don't work without the utility program. In this case, see
and check the operating manuals of the computer.
manuals search engine
Serial
SEL0
RTS
D-sub 15pin shrink terminal (Male)
GND
TD

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-x955e

Table of Contents