JBL ES250P (120V) Owner's Manual

JBL ES250P (120V) Owner's Manual

Es series

Advertisement

®
JBL ES SERIES
ES150P , ES250P (120V)
OWNER'S GUIDE

Advertisement

Table of Contents
loading

Summary of Contents for JBL ES250P (120V)

  • Page 1 ® JBL ES SERIES ES150P , ES250P (120V) OWNER’S GUIDE...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  • Page 3 INTRODUCTION ® ES150P/ES250P Powered Subwoofers For more than 60 years, JBL has been providing audio equipment to concert halls, recording studios and movie theaters around the world, and has become the hands-down choice of leading recording artists and sound engineers.
  • Page 4: Controls And Connections

    CONTROLS AND CONNECTIONS Rear Panel ¡ Phase Switch ™ LFE/Normal Selector £ Subwoofer-Level Control ¢ Crossover Adjustment ∞ Line-Level/LFE Input § Power Switch ¡ ™ £ ¢ ∞ § AC 120V~60Hz...
  • Page 5: System Connections

    SYSTEM CONNECTIONS If you have a Dolby ® Digital or DTS ® receiver/processor with a low-frequency-effects (LFE) or subwoofer output: Set LFE/Normal switch to “LFE.” If your receiver/processor does not contain a Dolby Digital or DTS processor, but has subwoofer outputs: Set line-level/LFE switch to “Normal.”...
  • Page 6: Crossover Adjustment

    If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your subwoofer ever needs service, contact your local JBL dealer, or visit www.jbl.com for a service center near you.
  • Page 7: Specifications

    SPECIFICATIONS Frequency Response Amplifier RMS Power Amplifier Peak Dynamic Power Crossover Frequency Driver Dimensions (H x W x D) (with grille) Weight † The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
  • Page 8 Features, specifications and appearance are subject to change without notice. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Elliptical Oblate Spheroidal, PolyPlas and Pro Sound Comes Home are trademarks of Harman International Industries, Incorporated.

This manual is also suitable for:

Es150pEs250p

Table of Contents