Portable wireless stereo speaker with passive bass radiators, 6000 mah battery for 15 hours of playing time and charging of other devices through usb, and ipx7 waterproof (39 pages)
Page 1
– and that when you think about purchasing additional audio equip- ment for your home, car, or office you will once again choose JBL. Please take a moment to complete the enclosed profile card. It...
The wires for both speakers should be the same length. If one speaker is placed closer to the amplifier than the other, hide the excess wire behind the wall. FM52, FM62, FM82, FM65C LEFT – – + LEFT Front or Rear Speaker Outputs...
However, if you are unsure of your ability to Tools Needed Phillips #2 screwdriver Pencil FM52, FM62, FM82 Installation Kit Template Retainer clips properly install these loud- speakers, please contact your dealer or a qualified installer.
Existing Construction Step One: Remove the grille from the speaker frame. Step Four: Cut the dry wall. Step Seven: Connect the speaker wires to the baffle assembly and install baffle assembly in frame. Do not overtighten the baffle screws. Level Template Tape Step Two:...
New Construction Step One: Remove the grille from the speaker frame. Step Four: Nail or screw the speaker frame assembly to the wall studs and route the wires through the frame opening. After the Drywall is Installed Step Five: Cut the drywall. Step Two: Attach the proper mounting bracket, marked and preset at...
Page 7
FM8SUB Step One: Remove the grille from the subwoofer frame. Step Four: Loosen the eight phillips head screws until the locking tabs turn inward. Step Seven: Screw down each of the eight phillips head screws. The tabs will swivel into place and secure the unit to the rear surface of the drywall.
Page 8
FM65CX Step One: Remove the grille from the speaker frame. Step Four: Remove 4 phillips head screws that attach speaker to frame. Step Seven: Screw down each of the three phillips head screws. The tabs will swivel into place and secure the unit to the rear surface of the drywall.
Page 9
Painting the Speaker Frame and Grille FM Series loudspeakers can be painted to match any style of decor. If you wish to change their color, the satin finish on the grille and frame will func- tion as a primer coat. Before painting install the paint guard (in the assembly kit) securely into the recess in the baffle.
Troubleshooting If there is no sound from either of the speakers, check the following: • Receiver/amplifier is on and a source is playing. • Check all wires and connec- tions between receiver/amplifier, in-wall room volume control and speakers. Make sure all wires are connected.
Tweeter: Outside Dimensions (HxW): Occasional refinements may be made to existing products with- out notice, but will always meet or exceed original specifications unless otherwise stated. FM52 FM62 50Hz – 20kHz 40Hz – 20kHz 40 watts 50 watts 88dB 90dB...