Table of Contents
Advertisement
5. Lift both hinge arms to the horizontal position.
6. Use the two view slots to align the pivot bar with the two pivot-bar slots.
NOTICE:
Using excessive force to pull the hinge arms into place may damage the arms or the front panel.
7. Pull the arms toward you until they snap into place.
If the hinge arms don't snap back into place on the first attempt, slightly reposition the arms and try again.
8. After the hinge arms clip into place, lower and raise the arms two or three times to properly seat them.
9. Reattach the front-panel insert.
10. Reconnect the power cable to your computer.
11. Reattach the front door as described in
Opening the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
1.
Shut down the
computer.
"Reattaching the Front
Door."
"Safety
Instructions."
Advertisement
Table of Contents
