Table of Contents
Advertisement
Usage
Turn Camera On
Turn the camera on and operate each of the housing controls to get a
feel for using the camera in the housing.
Zoom Control
After you have used the housing's
zoom control, it must be returned to the
center position to disengage. If the
housing zoom control is pushing the
zoom lever in either direction, you may
not be able to take a picture or access
other functions. This is because the
camera is receiving a signal from the
engaged zoom control.
Using the Camera's Built-in Flash
If you are shooting with the camera's built-in flash and the camera lens
is set to the widest angle setting, you may need to zoom the lens slightly
or a dark area may appear in a lower corner of close-up photographs.
The lens port may block some of the light. Install the Diffuser and zoom
in to eliminate any dark areas noted in your photographs (You can test
this above water). See Diffuser/Deflector Installation - page 10.
For the best results, we recommend using external Ikelite Substrobes.
The camera's built-in flash CANNOT be used with optional Wide Angle or
Accessory lenses.
(lever type only)
+
-
Zoom Control
"Disengaged"
(Center Position)
+
-
Zoom Control
"Engaged"
9
Advertisement
Table of Contents
