Table of Contents
Advertisement
Recommended Accessories -
Please Read If Using an EV Manual Controller
The EV-Controller used with Ikelite DS Substrobes has two user
settings. One setting is for strobe selection, the other is for pre-flash "P"
or non pre-flash " P ." Most cameras use a pre-flash. This means the
EV-Controller should be set to the pre-flash "P" position when used with
this camera as a slave. If a manual mode is used that does not emit a
pre-flash, set the EV-controller to the non pre-flash " P " position.
A full range of accessories is available to support your housing. Please
visit www.ikelite.com to see the most current information about
recommended accessories for your housing.
Customer Support
Please read the troubleshooting section of this instruction manual before
contacting Ikelite Technical Support.
Ikelite Underwater Systems
Service Department
50 West 33rd St.
Indianapolis, IN 46208 USA
continued
Email: ikelite@ikelite.com
Phone: 317-923-4523
21
Advertisement
Table of Contents
