Audiopipe DJAP-612PB User Manual page 8

42. BATTERY
These LEDs are used to indicate the power
of the battery.
43. EXT. DC 12V
When the AC and battery are out of power,
you can use the EXT. DC 12V supply to the
unit.
44. POWER AMP. Switch
Turn the Power AMP switch on "OFF"
position, the EXT. DC output will be cut
off, and the battery will store the power;
this switch on "ON" position, the EXT. DC
supply will work on normal condition.
45. SPEAKON Connector
This connector is used to connect with the
passive speakers. It is configured with a
speakon connector. You can determine the
signal that is out put to this jack.
NOTE: In order to avoid damaging your
built-in amplifier, please pay more attention
to the impedance of speaker. Lower load impedances are not permitted.
46. CLIP LED
When the output signal distortion exceeds 0.5%, then the red LED (Clip) indicator will blink. It will warn you that the levels of
the input signal are too high and may cause distortion. Please attenuate the level of the input signal.
47. TO MIXER
Put the Mixer on the bracket to adjust the volume, you can insert the connector into the TO MIX jack, and the unit can work on
normal condition.
48. PHONE Jack & SPEAKON Connector
These jacks are used to connect UPA-615 passive speakers. They are configured with a speakon connector and 1/4" phone jack.
You can determine the signal that is outputted to these jacks.
NOTE: In order to avoid damaging your built-in amplifier, please pay more attention to the impedance of speaker. Lower load
impedances are not permitted.
3.5 WIRELESS MICROPHONE SYSYTEM
Diversity Receiver
49. Antenna
The antenna receives signal from transmitter. Make sure the antenna is fully extended vertically for receiving best effect. Fold
both antennas inward for the convenience of transporting.

47
46
45
43
41
42
40
28
39
DJAP-612PB
DJAP-61PB DJAP-615P
47
44
46
48
40
38
39
DJAP-615P