Installation And Connection - Audiopipe DJAP-612PB User Manual

MATCHING WITH PASSIVE SPEAKER & SUBWOOFER
In this example, it connects a sub-woofer, and the woofer of this two full-range act like midwoofer.
This is very popular combination especially in small size clubs where there is no need for two sub-woofers.

6. Installation and Connection

6.1 Set-up
Ok, you have reached this point and you are now in the position to successfully operate your DJAP. However, we advise you
to read carefully the following section to be the real master of your unit. Not paying enough attention to the input signal
level, to the routing of the signal and the assignment of the signal will result in unwanted distortion, a corrupted signal or no
sound at all. So you should follow this procedure for every single channel.
-Turn down all input and output controls.
-Connect phantom powered microphones before switching on the +15V phantom power switch.
-Set the output level of your DJAP at no more than 75%.
- Now, set the MONITOR level at no more than 50%. In this way you will be able to hear later what you are doing by
connecting a pair of powered monitor speakers.
-Position EQ controls on middle position.
-Now repeat the same sequence for all input channels. The main LED meter could move up into the red section. In this case
you can adjust the overall output level through the OUTPUT LEVEL control.
6.2 Audio Connection
The DJAP is presented with balanced XLR sockets & 1/4" TRS jacks and unbalanced RCA connectors, and it can be interfaced
in several ways to support a variety of applications without any signal loss. The unit can be used on a single instrument by
connecting to a mixing console's main inserts, or a power amplifier.
-Wiring Configuration
Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which will be determined
by the actual application status, please wire your system as the following wiring examples:
OF F
DJAP-61PB DJAP-615P
Speaker
Cable
PASSIVE SPEAKER
From Monitor Out
1 1