Audiopipe DJAP-612PB User Manual page 5

effect device.
QUALIZER
The UPA features a 3-band equalizer which allows you to adjust the high, mid and low frequencies separately on each mono
channel.
5. HIGH
This is the treble control. You can use it to get rid of high frequency noises or to boost the sound of cymbals or the high
harmonics of the human voice. The gain range goes from -15 dB to +15dB with a center frequency of 12kHz.
6. MID
This is the mid range control. It can affect most fundamental frequencies of all musical instruments and human voice. An
attentive use of this control will give you a very wide panorama of sound effects. The gain range goes from -12dB to +12dB
with a center frequency of 2.5kHz.
7. LOW
This is the bass control. It is used to boost male voice or kick-drum and bass guitar. Your system will sound much bigger than
what it is.The gain range goes from -15dB to +15dB and the center frequency is 80Hz.
8. PEAK LED
This LED will illuminate red when the signal nears clipping.
9. LEVEL Control
This control is used to adjust the level of TAPE IN and 3.5 φ jack signal simultaneously. The adjustable range goes from -
to+10dB.
10. 3.5 φ Jack
This insert can be used to connect with a Computer, MP3, MP4 or
CD players.
11. TAPE IN
The UPA features dual RCA jacks (left and right). If you wish to
listen to your monitor from a tape recorder, DAT or cassette, please
use these tape input jacks.
12. REC OUT
Via these jacks, you can route the main out signal into a tape
recorder or DAT for recording.
13. MONITOR Control
This control isused to adjust the level of monitor output.
14. GRAPHIC EQ
Your DJAP is equipped with a graphic EQ, which provides 7-band
fader controls. Via these faders, you can boost or attenuate the
selected frequency by 15dB at a preset band width.When all faders
are at the center position, the output of the equalizer is at the flat
response. They are used to modify the frequency "contour" of a
2
33
31
32
14
9
10
DJAP-61PB DJAP-615P
14 34 30 36 29
11 12
37
17
35
16
13
15
19
18
20
21
5