Power Supply - Dell Dimension 2100 System Reference Manual

1 Microprocessor connector (J5H1)
2 Memory sockets (BANKn)
3 Fan connector (J3J1)
4 3.3-V power connector (OPTIONAL POWER)
5 Secondary IDE channel connector (SEC IDE)
6 Control panel connector (J9F2)
7 Floppy drive interface connector (FLOPPY)
8 Primary IDE channel connector (PRI IDE)
9 Power input connector (POWER)
10 Battery socket (BATTERY)
11 Wakeup On LAN connector (WOL)
System Board Configuration Jumper
NOTE: The red dot in the jumper denotes pin 1.
Jumper
Setting Jumper
Pins 1-2
jumpered
(Normal
mode)
Pins 2-3
jumpered
(Maintenance
mode)
Power Supply
Description
In Normal mode, system setup settings and installed passwords are
retained when the computer starts up. In this mode, an automatic recovery
is attempted if the BIOS detects that any of its main blocks are corrupted.
Starting the computer with the jumper set in Maintenance mode
automatically starts the system setup program, adds the Maintenance
option to the menu bar, and displays the Maintenance screen. This
screen provides the following option.
NOTICE: Entering Maintenance mode returns all settings in the
system setup program to their defaults. Dell strongly recommends
that you record or print all current settings before entering this
mode so that you can correct them when the computer is reset to
Normal mode.
Clear All Passwords — Disables a forgotten password so that you can
access the computer and assign new passwords. For the complete
password procedure, see "Clearing Forgotten Passwords" in the
Solutions Guide.
12 Speaker (LS9A1)
13 Configuration jumper (J7A1)
14 Power light
15 Card connectors (natural color) (PCIn)
16 Serial connector (COM1)
17 Parallel connector; sometimes referred to as LPT1
(PARALLEL)
18 Video connector (VIDEO)
19 USB connectors (USBn)
20 Mouse connector (MOUSE)
21 Keyboard connector (KEYBD)