Supplied Accessories; Symbols Used In This Manual; Attaching The Base; Mounting The Unit On Your Furniture - Emerson LC260EM2 Owner's Manual

6

Supplied Accessories

Owner's Manual Quick Start Guide
Remote Control and TV base and 4 screws (M4 x 20)
batteries
(AAA, 1.5V x 2)
Note
• If you lose the screws, please purchase (M4 x 20) Phillips head
screws at your local store.
• If you need to replace these accessories, please refer to the part
name or No. with the illustrations and call our toll free customer
support line found on the cover of this manual.
When using a universal remote control to operate this unit.
• Make sure the component code on your universal remote control
is set to our brand. Refer to the manual accompanying your
remote control for more details.
• We do not guarantee 100% interoperability with all universal
remote controls.

Symbols Used in this Manual

The following is the description for the symbols used in this
manual. Description refers to:
: Digital TV operation
ATSC
: Analog / Cable TV operation
NTSC
• If neither symbol appears, the operation is applicable to
both.
Registration card
Quick
IMPORTANT
Start

Attaching the Base

You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction. At least 2 people are required for these steps.
1
Check the text "FRONT" with "arrow" on the Base's
bottom to ensure it is being installed in the correct
direction. Spread a thick and soft cloth over a table as shown
at step 2. Place the main unit face down onto it. Make sure
not to damage the screen.
2
Insert 2 hooks under
the bottom of the main
unit into base holes
(shown by arrow ),
➀
then move the base in
the direction as shown
by arrow until it
➁
stops and the screw
holes are aligned.
Make sure not to put the AC power cord between the
base and the unit.
3
Drive Phillips head
screws into the 4
threaded holes at the
bottom of the base until
they are tight.
To remove the base from this unit
• Unscrew the Phillips head screws in step 3.
After the screws are removed, pull the base up toward the rear of
the unit. Be careful not to drop the base when you remove it.
Note
• When attaching the base, ensure that all screws are tightly
fastened. If the base is not properly attached, it could cause the
unit to fall, resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit
and is larger than this unit.
• Make sure the table is in a stable location.
• When attaching the base, ensure that "FRONT" with "arrow"
written on the bottom of the base is downward. If it's not
downward, the 2 hooks don't fit into the base.

Mounting the Unit on Your Furniture

Screw this unit on your furniture tightly using wood screws
(not supplied) in the 2 holes at the back of the base as shown.
• Recommended screw dimension : 3/16 x 3/4 inches (5.1 x 20 mm)
rear of this unit
Note
• When you remove this unit make sure to unscrew the wood
screws from your Wood Stand, Furniture and other wood item.
➁
➀
FRONT
screw holes