JBL Cinema Sound CS3 Owner's Manual page 30

LEARNING CODES FROM A REMOTE CONTROL
• Remember to press the appropriate Input Selector
before functions are changed to another device.
3. When all the steps have been entered, press the
button to enter the commands. The red light under the
Input Selector will blink and then turn off and the Program
Indicator will flash green twice, to confirm the macro to be
programmed.
Example: To program the Macro 1
CS3/CS5 and your TV, follow these steps:
• Press the Macro 1 and Mute
then release them.
• Note that the Program Indicator
• Press the TV Selector .
• Press the Mute button to store the CS's power on command.
• Press the Screen Power On
Command.
M N KL
• Press the Channel Up
process and store the macro sequence.
After following these steps, each time you press the Macro 1
button, the remote will send all Power On commands.
30
button
M N KL
button so that it turns on the
buttons at the same time and
will flash amber.
button to store the TV Power On
button to complete the
Erasing Macro Commands
To remove the commands that have been programmed into one of
the Macro buttons, follow these steps:
1. Press the Mute Button
contains the commands you wish to erase.
2. Note that the Program Indicator
LED under the Input Selector
3. Within ten seconds, press the Mute Button
4. The red LED under the Selector will go out, and the Program
Indicator will turn green and flash three times before it
goes out.
5. When the Program Indicator
erased.
and the Macro Button that
will flash amber, and the red
last used will turn on.
.
goes out, the Macro has been