Honda TRX420TM Owner's Manual page 113

6. Reinstall the oil filter cover, making sure the bolts are tightened to the
specified torque:
7 lbf·ft (10 N·m , 1.0 kgf·m)
7. Pour the drained oil into a suitable container and dispose of it in an
approved manner (page
8. Install the right side cover.
Improper disposal of drained f luids is harmf ul to the environment.
Add Engine Oil:
1. Check that the drain plug sealing washer is in good condition. If
necessary, replace the sealing washer.
2. Reinstall the oil drain plug and tighten it to the specified torque:
18 lbf·ft (25 N·m , 2.5 kgf·m)
3. Fill the crankcase with the recommended grade oil approximately:
2.9 US qt (2.7 )
4. Reinstall the oil filler cap/dipstick.
5. Start the engine and let it idle for 3 5 minutes.
6. Stop the engine, wait 2 3 minutes and check the oil level. Make sure
the oil is between the upper and lower level marks on the oil filler
cap/dipstick. If necessary, add more oil but do not overfill.
7. Check that there are no oil leaks.
8. Install the left side cover.
9. Install the seat.
If a torque wrench is not used for installation, see your Honda dealer as
soon as possible to verify proper assembly.
Engine Oil & Filter
170 ).
Servicing Your Honda
105