Table of Contents
Advertisement
Personal Mixing System Setup
This section explains how the A360 Personal Mixer integrates with other Pro16 devices (sold by
Aviom or third-party partners) to create a personal mixing system. See the detailed User
Guides that came with the Aviom products mentioned in this section for complete information
about their use, features, and setup.
Adding the A360 to an Existing System
The A360 Personal Mixer can be added to existing 16-channel personal mixing systems that use the A-16II
Personal Mixer (and/or the rack-mount version, the A-16R). Most of these systems use the same basic
layout—an input device (analog or a digital console card) is used to generate an A-Net digital signal which
is connected to Personal Mixers either in a daisy chain or with the addition of an A-Net distributor such as
the A-16D Pro for parallel connections and power over A-Net.
In addition to Pro16 analog devices and console cards, the Pro64 ASI A-Net Systems Interface may be
substituted for the input devices seen in the diagrams that follow. Any of the ASI's four Pro16 A-Net outputs
may be used.
Mono Mix Out
Mono Mix Out
Stereo Mix Out
Stereo Mix Out
Daisy Chain Connections
In a daisy chained Pro16 personal mixing system, the A-Net signal generated by the input module or
console card is passed from one Personal Mixer to the next, using the combination of the A-Net In and
A-Net Out jacks found on the Personal Mixers. Personal Mixers are powered locally with a DC power
supply.
The rear-panel mode switch on the A360 should be set to P
in a Pro16 personal mixing system with 16 or fewer channels. See page 45 for more information about the
mode switch and its use.
A360 P
M
U
G
ersonAl
ixer
ser
Uide
A360 rear panel with the mode switch set to Pro16
ro
A-Net In
A-Net In
Data
Data
PROGRAM
PROGRAM
CUSTOM
CUSTOM
DEFAULT
DEFAULT
Pro16
Pro16
16 when it is used with the A-16II and A-16R
24VDC
24VDC
Regulated
Regulated
500 mA
500 mA
56
Advertisement
Table of Contents
