Table of Contents
Advertisement
Aviom A-16II Personal Mixer User Guide
System Setup
Start with all devices turned off. When all power and audio connections
have been made, you can then power up all the components in your system.
Power Connection
The component parts of your Personal Monitor Mixing System use separate
external power supplies.
• Connect the DC power supply to the A-16II Personal Mixer
unit.
• Plug the power supply into an available AC power outlet.
The Personal Monitor System will be in its "on" state as long as it is
plugged into a working electrical outlet.
No on/off power switches are included on the A-16II. If you would like to
control the power state of your units, simply connect the power supplies to a
power strip with an on/off switch. Use that as a system power switch.
DC power for the Personal Mixer can optionally be supplied from an A-Net
compatible distributor, eliminating the need for the power supply at the
mixer's location. Refer to the documentation provided with the distributor
for more system setup information.
System Interconnections
A single Category 5 cable is required to connect each A-Net compatible
device in your system.
Connect a Category 5 cable from the A-Net Out jack on the input module to
the A-Net In jack on the first Personal Mixer.
Connect additional A-16II Personal Mixers with a single Category 5 cable
from the A-Net Out jack on the first Personal Mixer to the A-Net In jack on
the next Personal Mixer. (Repeat this process for each additional Personal
Mixer unit in your system.)
A-Net can also be distributed in parallel by using an A-Net Distributor.
This can eliminate daisy chained A-Net connections.
Audio Connections — Outputs
Plug headphones, in-ear monitors, powered floor monitors, or spot monitors
into the A-16II Personal Mixer's Headphones/Line output jack on the rear
panel of the Personal Mixer.
12
Advertisement
Table of Contents
