Loading A Mixer Configuration; Error Warnings While Loading And Saving - Aviom A360 User Manual

Loading a Mixer Configuration

A USB memory stick can hold up to 16 different mixer configurations, numbered 1 through 16, that
have been created using the A360 Channel Manager software or saved directly from an A360 Personal
Mixer. Custom channel maps and Mix Presets travel together as a single unit—the configuration file; the
underlying components of a configuration cannot be individually loaded.
Mixer configurations make it easy to copy Mix Presets from one A360 to another. They are also used to
assign a unique set of network slots for each performer and then quickly load those custom channel maps
into each A360 Personal Mixer in a personal mixing system.
To load one of the mixer configurations from a USB memory stick into an A360:
1. Insert a USB memory device into the
2. Place the A360 in
Pan, and channel button LEDs go out; all mixing functions are disabled.
3. The S and r
AVe eCAll
4. Press the r button; it lights solid and all mix channel buttons start blinking.
eCAll
5. Select the channel button (1-16) that corresponds to the mixer configuration you wish to
load. That channel button's LED lights solid, all other channel button LEDs stop blinking.
6. Set the rear-panel
must choose the C
Manager.
7. Remove the USB memory stick.
N :
When a configuration is loaded into the A360, any previously loaded channel map is replaced;
P
ote
Mix Presets stored with the configuration are also loaded and will replace any user-created
mixes saved in the A360. Always back up important data in a Personal Mixer before loading
configurations.

Error Warnings While Loading and Saving

While recalling a configuration, if you select a mix channel button that does not correspond to a valid
mixer configuration file stored on the USB device, the r
A360 will then revert to blinking the S
press the r button and select a different channel button.
eCAll
If you place the mode switch into the P
USB device prior to performing a save or load operation, the A-Net LED will blink as an error indication.
Simply reconnect the USB device to continue.
A360 P M U G
ersonAl ixer ser Uide
USB port on the A360.
P
mode using the rear-panel switch. All Reverb, Tone, Volume,
roGrAm
buttons start blinking.
mode switch in the desired position: P
position to use channel mapping created with A360 Channel
uStom
and r
AVe eCAll
position when no USB device is connected, or remove the
roGrAm
16, D , or C
ro efAult
button will blink as an error warning. The
eCAll
buttons as described above. As in the steps above,
. You
uStom
52