Tuner Operation - Jensen JCD2010 Installation And Operation Manual

JCD2010

TUNER OPERATION

1 5 3
15 7 4 17 9 10 11
Select a Band
Press the BAND button (21) on the control panel to change between three FM bands and two
AM bands. Each band stores up to six preset stations (see "Preset Stations").
Tuning (|<</>>|)
Auto Seek Tuning
Press the >>| (19) or |<< button (18) for less than 2 seconds to move to the next station
automatically.
Manual Tuning
Press and hold the >>| (19) or |<< button (18) for more than 2 seconds to enter manual tuning
mode. Press the >>| or |<< button to change the radio frequency number up or down one step.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (9-14) for 2 seconds. The
preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (9-14) to select the corresponding stored
station.
16 21 2
18
12 13 14 6 19 20 8
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select a band (if needed). Press and hold the AS/PS button (16) for more than 2 seconds to
automatically select six strong stations and store them in the current band. The new stations
replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press AS/PS (16) to scan stations stored in the current band. The
unit will pause for seven seconds at each preset station. Press AS/PS again to stop scanning
when the desired station is reached.
Stereo
The unit will automatically pick up an FM stereo signal, when available. When in stereo mode,
the " " icon appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.
Local/Distant Reception
To receive local radio stations with high transmitting power, activate the LOCAL feature. Press
the LOC button (6) to toggle between local and distant station receiving. In Local mode, the
"LOC" icon displays on LCD.
USA/EURO Tuning
Use the BAND button (21) switch between USA and European broadcast tuning.
1. Turn the vehicle ACC on and the radio off.
2. Press and hold the BAND button for 5 seconds.
The LCD will display either "USA" or "EUR" as the new tuning region.
7