Table of Contents
Advertisement
Quick Reference Guide
Parking and Charging
1. Maneuver the machine to the charging station.
2. Power down by pressing the on/off button on the control
panel.
3. The machine must be placed on a continuous charge for
18 hours for a full charge. Only 24-volt chargers with a
gel cell setting can be used. These chargers ensure that
the batteries do not overheat. Using any other charger
will damage the machine's batteries.
Exchanging Battery Packs
1. Set the parking brake.
WARNING: THE BATTERY PACK CONTAINS 4 BATTERIES, ALL
OF WHICH HAVE AN ACTIVE CHARGE THAT CAN CAUSE
PERSONAL INJURY. USE CAUTION WHEN HANDLING.
2. Position battery exchange cart to receive battery pack. Latch the
guide ramp into slots located above rear bumper. Lock the casters on
the Battery Exchange Cart.
WARNING: A BATTERY PACK WEIGHS 260 LBS. BE SURE
THAT THE EXCHANGE CART CASTERS ARE IN A LOCKED
POSITION TO PREVENT PERSONAL INJURY.
3. Press latch to release battery pack.
4. Using the handle, pull the battery pack onto the cart.
5. Release locking latch and casters.
6. Spin battery Cart 180 degrees, aligning new battery pack.
7. Engage latching gate and lock casters.
8. Push battery pack into place until handle latch locks.
Important!
The DuoBot should be inspected and serviced by a factory-trained and certified Intellibot service
technician every 250 hours. Call Intellibot Customer Assistance (1-888-837-0002) to schedule service.
© 2013 Intellibot Robotics, LLC All Rights Reserved v3
Page 17
Advertisement
Table of Contents
