NEC V230 User Manual page 71

Adjusting the Vertical Position of Image [POSITION]
(only when [16:9], [15:9], or [16:10] is selected for [ASPECT RATIO])
When [16:9], [15:9], or [16:10] is selected in [ASPECT RATIO], the image is displayed with black borders on the top
and bottom.
You can adjust the vertical position from the top to the bottom of the black area.
Turning on Noise Reduction [NOISE REDUCTION]
This function allows you to select the level of noise reduction.
The projector is set to the optimized level for each signal at the factory.
Select your preference item for your signal when video noise is noticeable.
The options are [OFF], [LOW], [MEDIUM], and [HIGH].
NOTE: This feature is not available for the RGB signal. Noise reduction set to off gives best image quality by way of higher bandwidth.
Noise reduction set to on softens the image.
Setting Telecine Mode [TELECINE]
This function allows you to convert motion picture film images into video. The process adds additional frames to the
picture in order to increase the frame rate.
NOTE: This feature is available only when an SDTV signal is selected.
OFF ........................ Turns off the TELECINE mode.
2-2/2-3 AUTO ........ Detects pull-down correction method.
2-2 ON ................... Uses 2-2 pull-down correction method
2-3 ON ................... Uses 2-3 pull-down correction method
NOTE: This feature is not available for 480p, 576p, 720p, 1080i and RGB signals.
62
5. Using On-Screen Menu