Rear Wheel - Yamaha FZ8NA Owner's Manual

Hide thumbs Also See for FZ8NA:
Table of Contents

Advertisement

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holders by
installing the bolt and nut.
6. Tighten the brake caliper bolts to
the specified torque.
Tightening torque:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
7. Tighten the wheel axle, and then
the wheel axle pinch bolt to their
specified torque.
7
Tightening torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Push down hard on the handlebar
several times to check for proper
fork operation.

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1
1. Axle nut
2. Lift the rear wheel off the ground
according to the procedure on
page 7-37.
3. Remove the axle nut.
4. Fully loosen the locknut on each
side of the swingarm.
7-39
EAU25080
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a) and
push the wheel forward.
EAU25314
EWA10821
1. Drive chain slack adjusting bolt
2. Locknut
6. Remove the drive chain from the
rear sprocket.
TIP
G
If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
G
The drive chain cannot be disas-
sembled.
7. While supporting the brake caliper
bracket, pull the wheel axle out,
and then remove the wheel.
1
2
(a)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fz8na(c)Fz8

Table of Contents