Maintenance And Care; Hard Floor Cleaning - Bissell QuickWash 1970 Series User Manual

0
perations

Hard floor cleaning

(included on select models only)
1. Remove the collection tank (refer to steps 2a
and b in the "To empty the collection tank"
section on page 6)
2. it is necessary to remove the cross
action brush first. Using your thumbs
squeeze the 2 grey tabs towards the outside
of the unit. Push down at the same time and
release the cross action brush.
3. Attach the hard floor tool by hooking it
into the front of the removable nozzle
and swinging it down until the tabs pop
into place.
4. Replace the collection tank. Be sure to
attach the two latches.
5. fill clean water/solution tank with BISSELL
hard floor Solutions to foRmULA fill line.
fill the rest of the tank with hand hot (not
boiling) tap water to the WATER fill line.
Replace and tighten the black cap.
6. follow steps 1-8 in "Carpet Cleaning"
section on page 6.
M
aintenance and care
When your done
1. Turn power lever off.
2. Unplug power cord from outlet.
3. Remove and empty collection tank.
a. Release collection tank latches [1 each
side] by pulling up from bottom of latch
and then out.
Carefully lift collection tank from
b.
lower body.
Carry collection tank to a toilet or sink.
c.
To empty, pour out contents using
opening at back of tank.
Rinse collection tank thoroughly.
d.
Remove lint and hair from red gasket
e.
in base of unit.
(do not remove gasket)
w w w . b i s s e l l . c o m
WaRning:
To reduce the risk of fire
and electric shock when
cleaning a hard floor, the
BISSELL hard floor tool
203-5547 must be used
and it must only be used
with BISSELL 2X Hard Floor
Solutions cleaning formula
intended for use with
this appliance.
3.
WaRning:
To reduce the risk of injury
from moving parts and/or
electrical shock, turn power
lever OFF and disconnect
plug from electrical
outlet before performing
maintenance or
troubleshooting checks.
7