Advanced
The Advanced screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
FIR Ports
Configure the system's Infrared port using options: Disabled and Enabled.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
FIR I/O Settings
DMA Setting for Fast IR
34
Description
Sets the base I/O address and IRQ for Infrared
port.
Sets a DMA channel for the printer to operate in
ECP mode. This parameter is enabled only if
Mode is set to ECP.
Option
Disabled
, COM1, 3F8, IRQ4/
COM2, 2F8, IRQ3/ COM3, 3E8,
IRQ4/ COM4, 2E8, IRQ3
DMA3
DMA1, DMA2,
,
Chapter 2