GE 45132 User Manual page 8

Step  - Set the Notification Mode to switch 'Alert'
position and begin activating Sensors one at a time.
Note: The sensor has a LED that flashes to show when the
sensor has triggered and transmitted to the main unit.
Step 4 - When testing is complete, unplug the AC
adapter, then plug the AC adapter back in and
reinstall batteries. This returns the Control Center
to standard operation mode.
Note: The Control Center will automatically return to standard
operation mode after 5 hours.
Installing the Sensor
Use the ball-head mount to mount the Sensor. The
minimum spacing recommended is 5-6 ft, depending
on where you want to mount the Motion Sensor. Once
the location is selected, before mounting you should
perform a manual test to confirm the Motion Sensor
is within range of Control Center. Refer to the Testing
a Sensor section on pg 7. Mount the ball-head joint to
the location with screws provided. Once the ball-head
joint is mounted to the wall, slide the back of the
sensor onto the ball-head joint. The mounting angle
can be adjusted.
8
TM