Bosch FNH180K-16 Operating/Safety Instructions Manual page 21

BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 21
13. As driver blade is inserted into blade
opening, align both guide rails into rail
holes on both sides (Fig. 27).
14. Securing driver sub-assembly to tool.
Frame assembly should align with
mounting holes for pins. Insert both pins
and push in (Fig. 28).
FIG. 27
FIG. 28
1. Remove metal cap. Using 3mm hex
wrench, remove 3 screws and set aside
(Fig. 31).
To replace drive blade, follow steps below:
FIG. 31
15. Pins should stick out an equal length from
16 Place metal top cap back on tool. Replace
(3) allen screws (Fig. 30).
Replacing Driver Blade
2. Remove drive block pin #1 by pushing on
one side. Pull on other end to remove.
*TIP* 16ga finish nail can be used to slide
pin out (Fig. 32).
-21-
both sides (Fig. 29).
FIG. 29
FIG. 30
FIG. 32