Panasonic KX-TG2721NZ Operating Instructions Manual page 21

Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
M N
2
MbN: "Base Unit Setup" a M
3
MbN: "Repeater Mode" a M
4
MbN: Select the desired setting. a
M N a M
Note:
R After turning the repeater mode on or off,
may flash on the handset momentarily.
This is normal and the handset can be used
once stops flashing.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold M
until the registration tone sounds.
R The next step must be completed
within 90 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and
green.
3
Base unit:
To exit the registration mode, press M
TG2721_2722NZ(en)_0807_ver002.pd21
N
N
N
N for about 5 seconds,
indicator light
N.
21
Programming
R The registration tone stops.
2012/08/07 10:29:47
21