Maintenance - Bosch FL10 Operating/Safety Instructions Manual

BM 2610022016 04-12_BM 2610022016 04-12 4/17/12 11:21 AM Page 8
NO USER SERVICE-ABLE
WARNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom -
mend that all tool service be performed by a
Bosch Factory Service Center or Authorized
Bosch Service Station. SERVICEMEN:
Disconnect tool and/or charger from power
source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
If an extension cord is
WARNING
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.

Maintenance

Service
Accessories
can cause the tool to operate improperly or
damage the charger.
Cleaning
To avoid accidents, always
WARNING
disconnect the tool and/or
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
Certain cleaning agents and
CAUTION
solvents damage plastic
parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that
contain ammonia.
RECOMMENDED SIZES OF ExTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50 100 150
3-6 18 16
6-8 18 16
8-10
18 16
10-12 16 16
12-16 14 12
-8-
Wire Sizes in mm
Cord Length in Meters
15 30 60 120
16 14 0.75 0.75 1.5 2.5
14 12 0.75 1.0 2.5 4.0
14 12 0.75 1.0 2.5 4.0
14 12 1.0 2.5 4.0 —
— — — — — —
2