Pressed - Denon DN-2600F Operating Instructions Manual

ENGLISH
Clearing all the seamless loop settings
Press the LOOP (FLIP) button for at least 2 seconds.
7
• When this is done, the settings for the start points (A-1
and A-2) and the end point (B) are all cleared.
NOTE:
• When A-1 or A-2 is cleared during seamless looping, it may
take about 2 seconds before A-2 or A-2 can be set again.
Fine-adjusting the start points (A-1 and A-2) and
end point (B)
The A-1, A-2 and B points can also be used to set the standby
mode at the respective point.
Adjust the start point (A).
To fine-adjust the position of the A-1 (or A-2) point once it
has been set, in the standby mode press the A-1 (or A-2)
button while pressing the CUE button.
CUE
1
• The standby mode is set at the A-1 (or A-2) point.
Use the scan or manual search function to fine-adjust the A-
1 (or A-2) point, then press the A-1 (or A-2) button again.
SEARCH
SCAN
2
6 7
Adjust the end point (B).
Press the A-1 (or A-2) button, then in the standby mode
3
press the B (B-LOOP) button while pressing the CUE
button.
• The standby mode is set at the B point.
As in step 2 above, use the scan or manual search function
to fine-adjust the B point, then press the B (B-LOOP) button
4
again.
• The end point (B) moves to the position at which the
button is pressed.
NOTE:
• It is not possible to set an A point at a position after the B
point or the B point at a position before the A point.
16
LOOP
LOOP
Off
A
A1 StdBy
1 2
A1 Moving Load A1
Hot starting
Hot starting is possible when no end point (B) has been set in the
seamless loop mode or when in the exit mode.
With the data for A-1 or A-2 loaded, press the A-1 (or A-2)
button to hot start.
• Playback starts immediately from the start point (A) when
the button is pressed.
1
• "H/S" is displayed when hot starting is possible.
If point B is set, set the exit mode.
When data is loading, hot starting is only possible for the
point (A-*) whose data is loading.
Stuttering
Stuttering is possible when the seamless loop mode is off and the
start point (A) is set.
In the stutter mode, press the A-1 (or A-2) button.
• Playback starts immediately from the start point (A) when
the button is pressed and stops when the button is
1
released.
• "STR" is displayed when stutter playback is possible.
When the PLAY/PAUSE button is pressed from the above
stop mode, hot starting begins from the start point (A).
NOTES:
• The hot start and stutter functions cannot be used when in
the next track mode.
• When the " " indicator is lit, it is not possible to set
LOCK
the pause mode or to use the manual search and scan
functions.